Posted by Tony in SD on December 27, 2023 at 16:01:56 from (104.167.204.193):
In Reply to: WILL THIS WORK?????? posted by lenray on December 27, 2023 at 09:40:03:
Anything can work and at the same time anything can fail. I have been involved with aerial communications construction most of my working life after college. What I will tell you is that you need to do whatever you have to do to make this contraption safe. First, know the OSHA rules for aerial maned lifts. You may not think they are very important but your insurance company certainly will. One of the most important OHSA rules is the you must be tethered with OSHA approved fall gear. I have personally seen the results of 4 untethered individuals that fell from a man lift. All come down head first; 1 died, 2 have no noticeable side affects just to look at them but both tell me they are still in constant pain after 30+ years since the fall, and the last one has a plate in his head and walks like one of Jerry's kids (no offense intended just a quick and easy description). Another big hazard are power lines. Best advice is, DO NOT CUT ANY TREES AROUND OR NEAR POWER LINES WITHOUT FORMAL TRAINING AND INSULATED TOOLS. I have no idea what the scope of your work is but whatever it is, be very careful and safe if you choose to do this.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
