Posted by T.R.K. on December 18, 2023 at 16:30:23 from (75.88.25.89):
In Reply to: Minneapolis moline BG posted by Tinkeround on December 18, 2023 at 08:24:19:
It is Minneapolis-Moline's 'Uni-matic' hydraulic system.
The leak where the control lever goes on the shaft is an o-ring. But you have to take the lever off, and then take the cover off the opposite side of the tank and pull the lever out that way. Then change the 0-ring and reassemble. The plate where the hoses come out is sealed to the tank cover with o-rings that have a rectangular cross section. I don't have any luck with the replacement o-rings White offers, but a regular round o-ring from NAPA that fits the groove seems to work fine.
You don't say where the leak is at your cylinder. If it is the piston rod, I think a new seal is available. be sure your rod itself has a good finish on it. The best seal in the world won't help if your rod is rusty or pitted. I had to have a new rod made and fitted to my cylinder at a hydraulic shop.
Welters Farm Supply in Verona MO. is a good place for parts. They helped be with hydraulic parts for My BG.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Experimental Tractors Article - by Danny Bowes (Dsl). Tractor technology appears to have nearly hit it's pinnacle of development. If you agreed with the subtitle, you are rather mistaken. Quite, actually. As a matter of fact, some of the technology experimented with over 40 years ago makes today's tractor technology seem absolutely stale by comparison. Experimentation, from the most complex assembly to the most simple and mundane component, is as an integral a part of any farm tractor's development
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
