I have 25/26 on the diagram - would/Could I also have 23/24 in the back end. My top cover is larger than shown and covers both gearbox and clutch gallery/chamber.
My shift rods move freally by fingers as do the gears at the bottom of the selector forks, but hit a hard stop. I can't tell if it's gear misalignment or selector rod/shaft. I have turned wheels and engine by hand to align everything by eye and still nothing. I have put cover on and run the tractor and once in 500 plus tries i got 3rd/4th! Reverse is slick as anything.
I might measure accurately the location of the selectors on the shafts and then undo the wire/lock nuts/bolts and try and engage gears with fingers- if this works I know it is a selector rod/ball/spring (23/24 above) issue and not a gear misalignment.
The gears don't appear to have dropped at all, and I have checked for lateral play with sa pry bar (gently). Please keep the advice coming - it is very helpful thank you, Mark.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Little "M" - by Donnie Anderson. They call me "Little M" and this is my story. For the past several years I have sat against the tree-line, where my parts have rusted and rotted away. For all of these years I have wondered just exactly what happens to old tractors? Times were not always like this. I can remember back to 1948 when I was a brand new John Deere Model M. A man and his wife came to the dealer and looked me over real good. After many talks with the salesman a deal was struck and I, along with a M2 plow, c
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
