Posted by caterpillar guy on November 15, 2023 at 17:34:16 from (47.26.14.222):
In Reply to: Be careful out there! posted by wore out on November 15, 2023 at 07:56:56:
It is a sad situation for sure. Our combine is 18 feet without a head on it and is only about a foot less than an 8 row corn head on it. It takes both lanes on a county road. It was this wide when he bought it. There are 18 inch or something like that added to the axle inside the final drives so not something you are going to put in and take off. We take the head off except for his one farm that has a ditch through it and to get there We block the intersection with a vehicle while we drive down the less than 1/4 mile to the drive by the ditch then duck into the field there. Only takes a minute for both the trip and an accident to happen. I just had a guy tonight coming to the drive at the house run out in front of me because I turn on my turn signal my drive is about 50-100 yards east past the intersection of the road by the west side of the house. I usually don't even use it for that reason. Tonight I thought being close to the intersection by less than a hundred yards It would be safe to turn it on. I guess not. He sure did stomp the throttle though.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that�s wha
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
