Posted by flying belgian on October 23, 2023 at 17:20:59 from (69.24.183.49):
In Reply to: Combine operation posted by sourgum on October 23, 2023 at 12:09:48:
I kinda disagree with the other comments. You can run a combine at 50 percent capacity but you have to adjust everything for that amount of crop ie rotor speed, concave clearance,fan speed and sieves. Then you can get a clean sample in the grain tank. That being said its hard to tell if you are running at 50 percent capacity but much easier to tell if you are running full capacity. I always watched the tach on my combine. Under no load it would run 2400 rpm. at 25 percent capacity it would still run 2400. At 50 percent still 2400. So I would increase ground speed until it pulled engine down to 2200 and adjust the combine to accommodate that much crop. Going across the field if the rpm increased I would speed up ground travel if pulled below 2200 I would slow down thereby always running combine at the same capacity I had thrasher set for
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Trailerin a Tractor, Chains or Straps? - by Staff. Another great discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: " I bought a trailer and plan to take my CASE VAS to some shows. I don't yet have anything to secure it to the trailer. So which is better to buy and use; the ratchet-type straps or binders and binder chains?
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
