Posted by wore out on September 23, 2023 at 11:10:05 from (64.255.159.199):
I pressed the old U-joint yokes onto new ''profile'' PTO tubing to replace the tubes that had be twisted by a customer who over-tightened the slip clutches on a John Deere batwing rotary cutter using a hollow hydraulic ''porta power'' cylinder and a length of 3/4'' ''all thread''.
This a a Euro ''Waltersheid'' star-shaped driveline.
It went quite well, to my surprise.
You can see the twist in the cutoff ends that were pressed out of the joint yokes.
First, I had to machine an area at the end of the tube to accept the round ''ring'' that supports the safety shield.
(The blue extension cord was NOT present during the actual operation of the lathe !)
It is tractor-related because the ''4430'' that pulls it is also in the shop for the repair of numerous hydraulic leaks.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Super Dexta - by Anthony West. The rusty blue tractor caught my eye as my truck zipped by the farm implement business. It looked so fornlorn amongst the lineup of newer equipment. But it was just the right size for my small farm. I stopped in and asked the proprietor for further information. "It's a 64 Ford Super Dexta", he said. "It's a tough little tractor, although it's a hard starter being a diesel and all." He did manage to get it running, compliments of a can of ether. Once started it putted along pretty good. It
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
