Posted by Jim.ME on September 11, 2023 at 16:47:41 from (67.242.176.154):
In Reply to: MF 200 loader posted by Kalamazoo on September 11, 2023 at 03:31:10:
Quoting Removed, click Modern View to see
I believe he is looking for the loader hydraulic oil dipstick, that hangs inside the frame post on the right side of a MF 200 loader attachment, from the vent on a length of chain; not the tractor engine dipstick.
Kalamazoo,
I think some had a pipe plug, about halfway up that right post, which was the oil level, don't remember if it was on the inside or outside of the post. If yours has a plug like that in one side of that side post, you can check the level there. If you don't get a measurement from someone, I suggest making one. If I didn't have a dipstick, I would figure out where 2-3inches over halfway up that post was and measure from the vent plug down using that as the full level, to make a dipstick.
You might get a better answer for this if you post your request on the Massey Harris & Massey Ferguson Forum.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
