Posted by rockyridgefarm on August 11, 2023 at 04:56:20 from (166.181.80.163):
Seed cleaning season is in full swing for me. I have my machine on a pair of 14k axles, which I had thought was more than enough. Well, once I had it built and rolled across a scale, I was surprised to find out it weighed 15,500lbs. I had no choice but to run with the too-light axles, figuring if I ran slow and careful, it d be ok. No dice. 1500ish miles and one axle was slightly bent. Start the search for a heavier trailer. This is over the course of a year and a half.
This past Tuesday , I was talking with the local welding shop, and was surprised to be informed that one can purchase torsion axles that are rated for more than 7k! Hmmm on to bookface marketplace and a guy in Monticello has some 10k axles listed for $5k. I popped down and bought them. As I was writing the check, he said "Well the other guy is gonna be upset". Apparently someone has been stringing him along for a month, but was "SURE he was coming this week"!
Next problem, wheels off a 7k axle won t fit a 10 k axle. Axle seller didn t have wheels, so back to bookface. Set of 5 for 1650 in Pecatonica IL. Drive down Thursday look at em, offer him 1500, and now I have tires.
Sad part is, I only paid 2200 for the trailer! At least I ll have no worries with the axles anymore
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
