Posted by Hydro10037 on July 30, 2023 at 14:49:34 from (174.238.163.243):
Hey guys I have a 1974 hydro 100 I bought back in the winter. The steering is stiff and will barely turn under 1500-1800 rpm s. Steers good once moving and the rpm s are up. So far my mechanic has replaced the mcv pump twice, the MCV valve, checked the flow divider, and I even ordered another used MCV body, and changed it but still didn t help. Only getting 250 psi at idle going to the steering pump at idle. He called herrs hydro and they instructed him to check the main hydro pump. They said anything over 300 psi was good. It tested at 450 psi. The main hydro is also very responsive and strong when running it so I don t think it s the main hydro. Right now we are grasping for any way to fix it. Also going to attach a picture from another post from a 1066 hydro about the routing of the hoses and a picture of mine. Is there any way my hard lines could have been Replaced and that is causing the problem?? Completely stumped as you can tell.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
