In this picture is the bucket contacting the underside of the boom arms in the area between the ears where the arrow points? If it does you can add shims in that area to reduce the trave to just under the stroke of your cylinders, similar to what John Deere recommends on some of their loaders to take the strain off the cylinder if pushing with the bucket in the dumped position.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: The Old Gold National Antique Tractor Show - by Cindy Ladage. Over the fourth of July weekend, the Illinois State Fairgrounds in Springfield, Illinois, was the site of the Old Gold National Antique Tractor Show. Tractors of all makes and models were displayed and separted into categories by their age. Deere, Oliver and even a Wards and Keck Gonerman were part of the crowd. A sea of red International Harvester's seemed to be the the model with the biggest showing. The crowd was decent for the scorching July heat. The opening day started o
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
