Posted by oldproudvet on July 09, 2023 at 07:41:54 from (208.123.26.50):
In Reply to: Grain Truck floor posted by dhermesc on July 09, 2023 at 06:40:05:
Not sure where you are, but here in west central MN the area is thick with small Amish saw mills doing production lumber work and and all kinds of custom stuff. Years ago I brought oak logs over to one and had 2 hay rack boards sawn. I've since replaced my trailer floor with boards and tongue and groove ones for the flooring in my 1949 Studebaker grain truck. I've never tried a retail store. There are farms with portable band saw mills all over the country and they'd also be worth talking to. A neighbor bought a manual band saw (you push the carriage thru the log) to cut some awesome black cherry logs for a table and a mantle. It's cost from NH was under 2 grand and did a nice job, not a 1/16 of inch variation on a 12 ft cut. Impressive actually. If I wasn't 80, I'd buy one. Good luck, be creative. Larry
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
