Posted by INCase on July 05, 2023 at 09:11:49 from (209.221.240.192):
Have 2 sliding doors on the machine shed. had to rebuild them as the old ones (probably original 1965??) we getting pretty punky and would get way out of square if you moved them and then the doors wouldn't close.
so i made all new doors with wood frame and steel siding. The on door i put a latch on at the wall and a pipe and pin at the center. then added a small board to each so they lock into each other at the middle. but at the outer end of the other door its kinda flapping in the breeze. the original doors had wheels on the outer ends that would keep the end of the door from moving too much. the wheels are long gone but won't work with the steel siding anyway.
was thinking of maybe a padlock hasp with the rotating eye by bending the eye end of the bar to fit the corner of the door and it would cover its mounting screws. the rotating eye would keep it closed if you didn't have a pad lock on it.
any other thoughts or ideas on keeping the outer edge of the 2nd door secure (wind and snoopers)?
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
