Posted by Bob Bancroft on June 26, 2023 at 04:39:59 from (71.115.181.32):
In Reply to: Re: Must be Monday! posted by caterpillar guy on June 26, 2023 at 03:53:31:
A few years ago I came back home here to find a younger fellow with his once nice 4x4 pickup in the road ditch. The ditch was a mess where he had tried to keep going. His comment was 'I almost got out'! He was clueless. At no time did he almost get out. And the side of his truck was a mess. He looked old enough he should have been on his own. But it sure seemed like a situation where mommy and daddy were providing the goods. If he had let off, and stopped, damage to the truck would have been minimal. Once when I was delivering fuel, a snow plow forced me off the road on a curve. It was either slice the left front of the fuel truck into the vertical cutting edge of the one way plow, or the ditch. When I slid into the ditch, the empty fuel truck rolled onto its side! Once extracted, I drove it off without any damage.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
