Posted by Tim PloughNman Daley on June 09, 2023 at 01:47:16 from (24.236.161.49):
In Reply to: Headlight question posted by Clapped 2N on June 08, 2023 at 08:42:51:
The INDUSTRY STANDARD Part Numbers for Sealed Beam Headlights are:
6-VOLT = #4019
12-VOLT = #4419
TAILIGHT BULBS:
6-VOLT = #63
12-VOLT = #67
IMPLEMENT (WORKLIGHT) LAMP:
6-VOLT = #4511
12=VOLT = #4411
NOTE: The first early FORD 9N used in 1939 were the large CM HALL truck-style headlights but sealed beams were not yet invented. These lamps used a plug-in bulb, p/n 9N-13007 available at JUST8Ns.
NAPA has nothing to do with numbers. Suppliers may have their p/n's so always use the Industry Standards.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
