Posted by NY 986 on April 30, 2023 at 18:27:46 from (67.249.255.74):
In Reply to: 88 vs M posted by DeltaRed on April 30, 2023 at 18:13:02:
I've got both and both have been here since new by my grandfather. I'd say the 88 has more practical power and is easier to operate/handle. I like both but would give the 88 the edge. The hydraulics on the M are quicker but is negated due to the belly pump going through the clutch. It would be interesting for me to pull a 3 bottom plow with each as sort of a direct comparison which I never got to do before. Back in the day when the cows were here the 88 would get barrel manure spreader duty and the M would get forage blower duty then I would make my best guess as to true power based on power requirements listed in the manual for each implement. The engine in the 88 is fresher versus the M. Both need a little TLC plus the rear tires are not in the best condition anymore so a head to head test will have to wait.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.