Posted by Dean on April 30, 2023 at 06:34:58 from (68.39.250.176):
In Reply to: Rotary Mower Question posted by knightstead on April 29, 2023 at 13:19:21:
Your 45 PTO HP tractor can handle a 6' rough cut mower in most conditions if the mower is not too heavy.
It is not adequate for a 7' cutter in anything but absolutely ideal conditions, then only if the mower is very light, you have front weights (or FEL) and no steep ground.
Your tractor cannot begin to handle a Woods BB840X, which is a heavy 7' cutter. I once owned one of these and it is a heavy cutter, around 1,400 Lbs., IIRC. I used mine with a heavy MF 60 PTO HP tractor and later a 90 PTO HP Kubota. The hitch components of your Kubota will not hold up even if it will lift it.
I currently use a Woods BB720X, 6' cutter (same series as the BB840X and also heavy) with my 53 PTO HP Kubota. My L6060 has sufficient power for most of my work but I have broken hitch components three times.
The BB840X is too big and too heavy for your tractor.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Threshin Demonstration - by Michael Delaney. Introduction I bring you greetings from Prince Edward Island, Canada. We are Canada�s smallest province but big on farming. Maybe you�ve heard of us. Potatoes are our biggest crop. However, there is lots of mixed farming here also. I have a small mixed farm with 25-30 cattle. I make very good use of old machinery. I have a 135 MF Diesel, Farmall H and 1/3 share in an Allis B. I have complete lines of tillage and harvest equipment, and a saw gear etc. I have everything one would
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
