Posted by BarnyardEngineering on March 27, 2023 at 07:25:10 from (161.69.57.47):
I assume my problem is because the seal of an NPT swivel connection depends on the machine fit between the chamfer in the female fitting and the "cone" in the male fitting.
I've got four NPT swivel elbows and two NPT straight swivels on my joystick valve and they ALL leak. No matter how tight I tighten them. They are TIGHT, no wiggle or swivel whatsoever, but they still leak.
Took them apart, can't see anything wrong, no burrs or anything like that. Tried teflon tape on the threads even though it's not leaking around the threads. Obviously that didn't work.
Before I go and spend another two hundred dollars on JIC adapters, are there any tricks to getting these to seal?
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Best Tractor? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew quite a bit of response. We see the question of "Which tractor is best for me?" asked quite often. We thought you might find the responses interesting. As always, the names of the people participating in the discussion have been left out - we did not request their permission to reprint their names in this article. However you can find this discussion in it's entirety in the Tractor Talk archives.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
