Posted by caterpillar guy on January 15, 2023 at 13:09:00 from (47.26.95.42):
In Reply to: Cutting edges posted by 550Doug on January 15, 2023 at 09:51:11:
For replacement cutting edges on loader buckets we used to use old grader blades, and cut off what was to long. We would clamp the grader blade to the bucket using it for the alignment of the new edge then cut the old edge out and weld the new edge in. By tacking it on both sides before welding we had less warp or weld pull. also would weld the ends to the side sheets first to hold them together better. Used to do it right on the loader frame. That way we could hold it flat for the top and with it tipped clear over we could weld along as a crosswise vertical then finish with it unpinned and held upside down or we might just finish it tipped over still on the frame. Would take about a day between milkings at the time. Sure would scrap good for awhile that way.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Roof Palomino - Tractor or Jeep? - by Steve Nelson. My father-in-law purchased this jeep-like lawn mower back in 1968. He says he paid $1600.00 for it, which was big bucks back then for a mower. My own father bought a VW bug the same year for the same price. Well it
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
