Posted by Janicholson on January 13, 2023 at 17:12:14 from (24.240.46.228):
In Reply to: Um....Advice anyone? posted by jd2cyl1943 on January 13, 2023 at 16:54:03:
Use Gorilla glue on the handle (wet both surfaces with water!) then apply the glue in three stripes down the length of the split, each glue stripe should be 1/8inch wide/tall. Put the two pieces together as they were, and tape the handle with electrical tape stretching the tape as you layer it on spiraling to the other end. Let it stand in the house for 24 hours. Leaving the tape on is not a bad idea either. Overstrike is hitting the handle on part of that which is the target. From the looks of the handle near the head, it has seen multiple handle hits. On the piston put A new batch of PB Blaster juice on the top of the piston, wait for the handle to heal, and use a hard wood block that just fits in the cylinder. White Oak or maple is nice. Then pound on it some more! Jim
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.