Quote: CVPost-jon f mn (quoted from post at 21:41:50 01/12/23) The case VAC or later 300, 400, 500 or
even the 30 series of that size would fit
the bill. The vac will have a top speed of
around 13 or 14,but the others are faster
and if you get one with triple range they
go over 20 mph. A decent running and
looking vac will start at 6 or 700 and a
the others will range from that up to
around $5000 for aa nice 530 diesel com.
I ran an early Case 930 some and still remember the hydraulics slamming my knuckles into the fender!
My searches for Case tractors in general hasn't turned up anything reasonable in terms of general condition.
I have searched for a Case 530 off and on without any success. If I could find a "Wheatland Special" in reasonable condition, I wouldn't have any issues going that direction.
For whatever reason, the W-4 series seem to be much more available so, that has been the focus of a lot of my searches. I guess Case getting bought and merged for whatever reason killed off the support of the later generation tractors generally.
This post was edited by sidpost on 01/12/2023 at 08:42 pm.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.