Posted by redforlife on January 07, 2023 at 21:29:06 from (174.213.208.217):
In Reply to: Baler for plastic posted by tomstractorsandtoys on January 07, 2023 at 16:32:03:
I could see a guy having problems burning it, if that was all you were burning. Perhaps you should try to burn it with other stuff. Brush pile, or small amounts in your household trash, or wood burning stove. Anything that you can kind of blend it with when burning.
Plastics sometimes can be about like burning books or magazines. One book or magazine thrown into a fire will burn really well. But a whole burning barrel full of books don't burn worth a dang. You can kind of have this same effect when burning plastics. Avoid burning nothing but and only plastics, is really the solution.
I'm not sure that I would dismantle a baler and try to set something up just to see if it would work. I'm actually thinking that it would be about as likely to not work (or not work good enough), than likely have something that worked when you got done. But, ... if you got a baler that you wont bale straw or hay with again, and you got some time on your hands, then go for it.
I remember one time somebody was going to use a trash compacter to smash aluminum cans in. Nothing but cans and only cans. It didn't turn out well. It smashed em all right. But you couldn't hardly get em out of there once they were smashed. Concept worked, but it was one of those deals that it really wasn't worth doing. More grief getting the smashed cans out of there than it was to just smash em some other way.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
