Posted by Tx Jim on December 31, 2022 at 03:46:15 from (156.146.177.2):
In Reply to: 3 Point Problem posted by rusty6 on December 30, 2022 at 21:55:33:
My guess is rockshaft piston seal part #AL33017 has failed causing rockshaft to lower then raise continuously while engine is operating. This condition has been referred to as "hiccupping"
I agree with EDF that the small o-rings have a long history of wearing out. I suggest to remove rockshaft housing & replace all o-rings under the housing in conjunction with replacing RS piston seals. All o-rings/backup washers to correct your tractors 3 pt problem should be in a kit.
3 PT control lever has friction washers that need to have more spring tension or are worn out that were designed to keep 3 pt control lever stay where operator places lever. Which according to 2140 parts schematic could had adjustable or spring tension.
Rate of drop screw only controls how fast 3 pt lowers but has zero to do with 3pt raising speed. R-O-D screw can be turned fully clockwise to stop 3 pt from lowering if piston seal is holding pressue.
This post was edited by Tx Jim on 12/31/2022 at 03:55 am.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Field Marshall Tractor - by Anthony West. Any restorer who has some knowledge of turn of the century farm machinery, will recognize the name Lanz Bulldog!! This machine was to say the least unusual in its appearance. The huge flywheel and coffee percolator shaped exhaust. Along with square body lines and cylinder head protruding forward of the front axle. Would become the visual differentiation that people would quote to separate the Lanz from other period machines. The Marshall company based at the Briannia Works in Gainsborough
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
