If you have to buy wood I'm so sure it is a practical solution for heat. I have plenty of wood available from fence row trees cutting limbs to clear equipment each year plus all the dead wood to cut. Rarely cut a live tree. If we do it is for logs to make lumber to build sheds or something else like that. Then we don't waste the tops either cutting them for Wood down to about your thumb size also. Though at times I think the old buzz saw would be more efficient for that smaller stuff than a chainsaw. You can cut several pieces at once with each pas of the blade. Dad and I talked about if we would have enough dead fall stuff along with other wood for both of us in the past when he put in his wood furnace since it would do all the heating now instead of having some oil heat. That was over 20 years ago and still no problem with dead wood for heat. And everything makes heat junk wood like Boxelder and Pines.Yes grandpa planted a bunch of pines on some steep slopes with the Cat to pull the trans planter 60 or more years ago. We cut Christmas trees out of the tops of some of them for decades and now are cutting the dead ones for wood. It has thinned it out some but still has a lot left. Wood does not necessarily make dirty air and I don't mind wood smoke smell, better than the garbage burning I used to smell around areas. Electric heat is just not an option in most places and the grid can't supply the amount you want everybody to draw from it with electric heat even if the hoses were insulated a foot thick and so tight you could hear the air rush as you open the door to go in or out. You need coal to make steel for those housings for your fine batteries you so proudly purport to every body hoe great they are. Those nice cars you want to drive around and all those other products you want /like so much all have steel in them and they need coal for the coke to make it.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
