Posted by Geo-TH,In on December 09, 2022 at 06:07:16 from (50.127.118.18):
If you want to know what I'm talking about scroll down to my post, Round 2 it experiment I discovered the ammeter was responsible for the missing voltage in my series circuit. By removing the ammeter, the sum of the voltage across the ballast and the coil voltage added to equal the battery voltage. So the hair like lead wires to the ammeter were too small.
So I ordered 20 bananas connectors from amazon. HiLetgo 20pcs 4MM Banana Plug Male Audio Speaker Jack Amplifier Banana Plug Terminal Connectors (10 Red + 10 Black) I plan to make 20 voltmeters leads using 14g wire. I have some alligator attachments so some of my leads will have a banana connector on one end of the leads and an alligator clip on the other end.
I ordered a ballast resistor from amazon for my Jubilee. I will use the Jubilee's 6v coil and new ballast resistor. I'll put the 6v coil in series with the ballast resistor and measure the voltage across each. If I measure the same voltage across each, coil and ballast, that will tell me each has the same resistance, 1.5 ohms. I don't have an accurate ohmmeter that can measure 1.5 ohms.
Funnies What do you call a super conductor? Ohmless. What do you call your brother that became your sister? A trans-sister.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
