Posted by L.B, on November 29, 2022 at 19:12:33 from (64.187.67.141):
JD Forum -------I ask for help with a Hercules motor as I needed to see what JD used for a carburetor on a L and a LA. I was told that they used the same carburetor as my Hercules.----- Your reply was You might take a REALLY novel path with this and tell us the model of the carb (or post a photo) and drop a few hints as to what specific parts you need. I had no carburetor to take a photo of or anything else to go by. You failed to comprehend the ? you just wanted to gig me after you lost on the debate on the other forum it was a debate not a troll. I forced nobody to reply, if ya dont like the subject turn the channel.I have posted 100s of posts---go read them and find one that is a troll.You can see though that the replys here say alot as to what I was trying to point out have now come to pass. I told someone on the oil subject not to put detergent oil in a tractor that has used ND oil, clean the sump and valves before you put detergent oil in. My 43 has never used anything but ND oil,that all. You have now trolled me 3 times.L,B. Master of the Obvious.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
