Posted by caterpillar guy on November 20, 2022 at 02:20:41 from (47.26.95.42):
In Reply to: Diesel in gas posted by mmfan55 on November 19, 2022 at 16:02:35:
I don't know if it will separate or not never bothered with mixing and letting set to see. I would just drain off the tank then add more gas to the mix as time went on and use it up. Or you could use some of it in your diesel tractors tank this winter for the antigell that gets beat to death about every 2 weeks on here. We had a gas supply issue 50 years ago, with the local supplier either not filling, or over filling when he was here, so we ran short of gas during spring planting one year. Mom would get 15-20 gallon of gas at the station and I would pour in about 5 gallon of diesel fuel and tractor ran fine on that plowing. would fill then go plow or disc it out then have to refill again did that for a weekend never bothered the tractor and never went to burning oil either just ran a wee bit hotter on the temperature gage on a hot day. This was on an 830 Case. Straight gear transmission.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Ferguson TO-20 - by Staff. When the infamous "Handshake Agreement" between Henry Ford and Harry Ferguson fell by the wayside (that's a story in itself), Harry Ferguson quickly set up manufacturing plants for a United States version of his English TE-20. The TO-20 was relatively the same as the TE-20 except utilized some different casting materials and had a US-style electrical system. The TO-20 was a dead ringer for the Ford 9N and 2N models and they say that Ferguson did this on purpose when the Handshake Agreement wen
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
