Posted by Parker S. on November 16, 2022 at 19:22:57 from (38.53.136.125):
In Reply to: Servis FS15 posted by Parker S. on November 11, 2022 at 19:19:42:
Quote: Jim.ME (quoted from post at 04:14:21 11/16/22)
You don't say how much bigger the lip for the bearing is. It would sound like that style axle would be held in a four-bolt clamp on the arm, rather than the split type you have.
I would not try spreading it much more than you have. Cast is tough but it will reach a point where it just snaps, not bends. You need the same diameter on the axle where it goes through the arm as the old axle has. Can you have a sleeve, for the bearing set against, made to go on one end of the axle after the axle is installed into the arm?
The dual axle looks exactly like the single pictured, just with a washer/sleeve (about half an inch larger than the axle all the way around) on both ends and it has the same arm with bolt holding it in. A 4 bolt clamp would have been much easier. Would you suggest grinding the old washer/sleeve off and welding a new one on after sliding the axle back in? Was just worried about a lot of heat possibly damaging where the bearing seats.
This post was edited by Parker S. on 11/16/2022 at 07:24 pm.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
