Why not consider hydraulic drive. With a closed center system you can still run the jump auger while slowing down the throttle, so the 8 inch will run full. Other option would be to use a double auger flight with the 6 inch would move more and keep up with the 8 inch better. A belt and set of pulleys on the end under the truck would allow for one drive to run all of it. this would probably require a 2 horse motor for the double and about 1-1/2 horse for the single. We run about 23 foot 8 inch load out auger with 5 horse and works fine. Runs full bore about into a 10 inch to the truck from bin. My brother has a hydraulic set up for running his load out on a couple bins with no power to them. Will keep an 8 inch load out going and run the 8 inch up to truck with PTO. He uses his 2940 for it. I would like to see if one of the open center system tractors would work for that then he could keep the tractor within a mile of the bin when loading out.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Great Escape - by Dave Hollrah. It all began Monday with a little baling of second crop on the lake shore field, and as I drove out past my sister and her hubby's place, this small calling sound could be heard from the general direction of their manure pile. Out of the yard, over the cows and bale piles, through the dozer piles, poplars, and brush, out onto the ditch grade road, past the noisy 6.2 diesel engine pulling my well traveled Suburban along. Well it sure didn't take me long to figure out what it was because I alrea
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
