Posted by ss55 on October 31, 2022 at 01:09:45 from (96.42.227.92):
In Reply to: Heating my garage posted by andy r on October 30, 2022 at 18:52:59:
I did something similar 25 years ago in a lightly insulated three car attached garage. The cost to install a 40,000 BTU vented natural gas ceiling furnace with 80 feet of gas line was about $1600 at that time. It was sized for a modest 40 degree heat rise over the outside temperature. Installation, chimney, and gas line was well over half the cost. Going to a larger unit would have required a larger diameter gas line. For me, adding more ceiling insulation was cheaper than upgrading to a larger furnace. The cold concrete floor still absorbed a lot of heat fast. Your $4000 quote sounds like it is in the ballpark.
Electric heat will generate 3.4 BTU per watt. A 5000 watt heater will only produce 17,000 BTU, a 7500 watt unit will produce 25,500 BTU.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.