Posted by MarkB_MI on October 17, 2022 at 16:56:10 from (174.240.129.165):
In Reply to: Re: Shop Wiring posted by Geo-TH,In on October 17, 2022 at 14:28:55:
> I don't care if it has a 100 amp plug. > Circuit breakers are designed to protect the wire, not the welder, agree? > Why would I change to 8g wire when 10g wire has served me well for 30 years? Code or no code!
George, what you do in your own shop is your business. But when you're handing out advice to others, it's best to be conservative in your recommendations. The OP may have a puny welder now, but he just might buy a 300 amp TIG welder tomorrow. If you're putting in a 50 amp outlet, it ought to be good for 50 amps.
30 amp and 50 amp double-pole circuit breakers of the same brand and type typically cost the same. And with a short run, he's only buying a few dollars worth of wire either way. There's no good reason for him to wire the circuit for 30 amps rather than 50.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil�s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
