I have never had a chart for setting the precise amount of seed per acre. I usually planted Alfalfa 80% Timothy 20%. Or Alfalfa 40% Red Clover 40% and Timothy 20% mixture and at the rate of 12-15 lb per acre. Always would start out on a smaller field, that I knew how many acres there were, say 10 acres. And knowing I needed 150lb roughly, Id fill the seed box, and start out with what I though to be a slow seed flow setting, maybe a quarter of the seed flow gear pulling the seeds. After I planted half the field I would judge how much seed I had used, if I had 75lb of seed in the drill, and it ran out before half way, obviously too fast a rate of flow, and slow it down. My seed drill had a acre meter, and I could also just put in 15lb of seed, and strike off, checking on the consumption rate several times to make certain I didnt run out before the first acre. And adjust accordingly and the end of the first acre if there was too much left, or ran out to quickly. Not an exact way to measure but a side from wasting seed by putting down too much, it wont really be noticeable if you are only putting down 8lb when you wanted 12lb on your test plot. Once you have your drill set close to the amount you wish to plant you probably will never adjust it again. So spray a shot of pain on the seed feeder wheels/sprockets and you can tell at a glance if the adjustment has changed. By the time you have planted a few crops , you will have a better understanding of the drill and what I am saying.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Your Tractor - by Staff. Maybe you bought it from a friend who didn't know what kind of tractor it was, or perhaps (and this is every tractor fanatics dream) you stumbled across it in an abandoned field covered with weeds but intact. In any case, you have no idea what the make and/or model is. For awhile perhaps it doesn't really matter. Especially if it runs! But pretty soon you'll probably need to tinker with it a bit and maybe buy a part or too. Having a manual is nice. But how does one go about dete
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
