Posted by used red MN on September 18, 2022 at 22:19:47 from (75.73.112.20):
In Reply to: Fast hitch posted by flying belgian on September 18, 2022 at 18:22:28:
Sticking my neck out again, I do not think IH felt the Fast Hitch was rated for tractors over 100hp. I do not think the Fast Hitch was offered from the factory on a four digit model 10??, 12?? or 14?? If you saw an actual Fast Hitch on the tractor it may have been dealer install with 966 parts or farmerized. If you were just looking at wording in an add IH did offer the common 3 point ..Quick couplers.. if that was possibly confused. See the 1066 parts diagrams in the link, the hitches are in the ..Frame.. section. The 3 point tugs do mount in like the fast hitch prongs. However, if you look at the 966 parts the Fast Hitch is shown with the rigid ..wishbone.. that holds the receiver sockets at a set spacing.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
