Posted by caterpillar guy on September 13, 2022 at 10:37:00 from (47.26.95.42):
In Reply to: Flag Holder For Tractor posted by Kelly in tx on September 13, 2022 at 08:06:40:
A bar to bolt on the front mount then weld a couple pieces of pipe or tubing on at and angle. Drill a hole for a setscrew and weld a nut on the back side so you can tighten the flag in to remove afterwards. I don't put the bolt set to screw in from the back but in to a side so the flag can set against the tube when under side stress. The end of the bolt will tend to cause it to break at the bolt. A chain link can be used for a thumb screw handle to tighten and loosen. I did this for over size flags on the truck and they have more stress from wind at 70 MPH than with a tractor at 15-25MPH. the flags were 24x24 inches also.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - On the Road with Dave Gohl: Deere Departed Friend - by Dave Gohl. Have you ever had to part with a dear friend? It's not easy. If it's due to death, your feelings could be in disarray for days, months or even years. Even now after almost 4 years, I still miss my dad. I remember when I was a kid my dad sometimes would tuck my brother and I in at night and we would ask him questions about his childhood on the farm. To this day, it's some of the best stories I've ever heard. And now, I'm so glad that I asked those questions, and if I were a little smarter i
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
