Well, you have a few options depending on what you intend to do with this crop and how much money you want to spend. First of all, we know that you have a Farmall M. Probably without a 3-point hitch. That doesn't mean you're stuck with only pull-behind mowers. Right now, as we speak, there is a mounted IH sickle bar mower for sale on the YT ads. It's in the TRACTOR PHOTO ADS. Ad #724506. It's mounted to the drawbar of a tractor similar to your M but a little newer. $500. Located in Millington, Michigan. That's about as cheap as you're going to find. A pull behind rotary Brush Hog type mower would do the job but it would chop the grass quite fine and if you wanted to take some eff for hay or bedding either now or in the future, that wouldn't be the way to go. I traded in a good but well-used 6' Land Pride rotary cutter about a year ago and it sold off the dealer's lot in about a week for $995. If you're planning on some sort of future hay crop then there are better mowers than a sickle bar but more $$$ as well. It sounds to me like you're planning to just let this all develop into its natural state. If that's the case then a plain old sickle bar mower might be the answer. The one I mentioned is a 7' cut. If you go rotary cutter a Farmall M will handle a 6' or 7'.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let�s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
