Posted by used red MN on August 17, 2022 at 19:46:03 from (75.73.112.20):
In Reply to: Case 1594 lift posted by Hilldrop on August 17, 2022 at 18:11:53:
Hello hill welcome to YT! Once it raises does it hold position? When you throttle the engine down does it just start lowering? That would be a sign the seals are blow in the 3 point lift cylinder. If you do not use the 3 point does the hyd. oil heat up either way? I assume your cooler valve only protects the cooler coil from over pressure. I am attaching the CNHI parts diagrams for your tractor. Go to Hydraulics section 8, subsection 258, what I am talking about is number 1. It also shows a ..dump valve in section 280. Another odd thing, does it mention that in you book? I would suggest you buy a service manual. YT does offer a IT manual, but I suggest then actual Case Repair manual, the one in the 2nd link is downloadable.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Museum Coverage: The Stuttgart Agricultural Museum - by Cindy Ladage. While cold wind was blowing back in Illinois, in Arkansas, daffodils were in bloom, and the Magnolia trees were adorned with fragrant blossoms. Stuttgart, Arkansas was the site of this year's winter Minneapolis Moline Collector's show February 25-27, 1999. The show was held at the Oliver Museum created by Don Oliver, the pioneer of the four wheel drive tractor. Oliver along with Gale Stroh and Kenneth Bull using Minneapolis Moline tractors and parts created what has become known as
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
