Posted by old-9 on July 19, 2022 at 15:45:39 from (71.222.220.202):
In Reply to: Gas transfer pump posted by Freddie2010 on July 19, 2022 at 13:38:31:
I too am 75 way to old to hoist gas cans. few years ago I started using 6 gallon OMC ( Evenrude) gas cans for transport. I fill them on tailgate so I do not have to lift the weight. The marine tanks have a quick connect for the hose and in the line a primer bulb. I bought an inline 12 volt fuel pump (ebay) I wired it with a dead man switch (monetary contact NO) push button switch with battery clips. So now you have a 1/4 inch hose with a 12 volt pump and what ever length you want, quick connect on one end . I pull tractor up to tailgate and just pump into tractor. After using this way I ended up cutimg the quick connector off and just inserting into the gas can, works OK but slow. If I need to move 6 gallon tanks I just use a hand truck. Works for me, email open if you want more info. joe
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
