Posted by Hobo,NC on July 17, 2022 at 06:21:19 from (75.137.54.152):
In Reply to: Local show Cub Arama posted by Hobo,NC on July 16, 2022 at 17:56:44:
I can get up with the owner of the setter and find out Yes it attached to a draw bar and was driven buy a chain to automatically dispense water. You can see the water valve at his left knee.
I am almost sure the owner of the baccer is Gary Thomas he has 850 acres of it scattered about. No doubt it was irrigated as its been dry here also. Chuck Mann the owner of the property is retired and very inviting to anyone that stops by for a look at his stuff. His address is 1704 Broadway Rd, Sanford, NC 27332 are close his driveway is marked Farmall Ln. Chuck show me a pix of Garys new irrigation gizmo he said something about it being a 16 row and coast 1/2 a mil. but don't hold me to that.
I have brought parts and tractors from him in the past he has loaned me special tools when needed.
Geo Whut's a Baccer setter.
One side totes water you drop the plant in the other side push it in the ground pull a leaver to open it up. The plant falls in the hole and its given a little water. The trick is when you pull it out of the ground the mechanical jaw/nose of the setter does not pull the plant out of the ground. Several folks told me it was not easy as it sounds it was a art to pull it off consistently.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Torque Wrenches - by Curtis Von Fange. When working with fasteners a torque wrench can play an important role in the correct assembly of critical equipment components. Lets examine in detail some of the reasons for using a torque wrench along with how to correctly use the variety of wrenches available. Applying the proper torque to a fastener accomplishes a number of tasks. First of all correct torque will hold the parts together. This may seem like a trite statement but � think about it for a second. Engineers have designed
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
