Posted by Wheat47 on June 27, 2022 at 21:44:01 from (38.97.192.169):
In Reply to: A/C B power unit. posted by Wheat47 on June 27, 2022 at 17:17:05:
Just got in shortly after 10PM. Got the biggest and best share done. Got the best done, so a guy can hopefully pick up 40 or so bales tomorrow or the next day. Engine ran pretty good. Didn't want to pull very good, so I had to go pretty slow. Got a couple one-acre patches left. But it got dark, and those two patches involve a fair amount of turning on top of myself. I'll get them tomorrow evening. Probably got 8-10 acres left to cut. Probably cut 1/2 or so of it tomorrow. But then maybe I'll wait. Possibility of some showers in the future. Anyway, things are looking up!!! Thanks for the suggestions. I may try the wet rag thing. I can't take the hood off.....part of the radiator shroud and gas tank mounts. Thanks to all again!!! jon i may take the carb apart and check the float level too.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Machine Shops - by Curtis Von Fange. It is a story that repeats itself countless times. In the process of rebuilding a particular section of the tractor there is a broken part for which a replacement cannot be found. The parts houses find in their catalogue that it is unavailable. The dealerships call it a discontinued part. Salvage yards define it as hard to find or, even worse, rare. Everyone on the NET says, 'what is it?' But don�t despair there is another avenue that can be used to get that piece repaired. The local mach
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
