Posted by Steve@Advance on June 18, 2022 at 09:05:47 from (99.190.215.237):
In Reply to: Farmall 65A posted by flying belgian on June 18, 2022 at 08:17:53:
Something to try, get some spray contact cleaner, clean and blow out the safety switches. They may be full of grit and dirt.
What type solenoid does it have? A plunger type mounted on the starter, or a remote contactor type?
The remote type require very little power to energize them, but the starter mounted ones take a lot of amps to overcome the spring and pull in the starter drive. Often they fail to pull in because there is too much resistance in the wire and all the safety switches. Being it acts up cold, there could be cold gummy grease in the starter that loosens up once it's warm. Adding a relay near the starter will almost always solve the problem if it is the starter mounted type solenoid.
Still you need to catch it in the act to positively locate the problem. Try connecting the test light before even trying it, that way you will be ready to catch it.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Revival of a John Deere Combine - by The Red, John Fritz. For several years I had been driving by a farm house on the west side of Indianapolis that had a John Deere combine parked in high weeds in a lot behind the house. The gentleman no longer farmed because the entire area was developed with housing and light industry. I had stopped several times and knocked on the door but no one would answer. My curiosity was up and I wanted to contact the owner. I wanted to see what he planned to do with the combine.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
