Posted by Determined on June 08, 2022 at 06:27:08 from (216.130.218.7):
In Reply to: OT...cattle dart guns posted by Fred Werring on June 07, 2022 at 06:26:35:
Medi Dart is the brand of the one I have.
It comes with a crossbow to shoot it, they also make a version that goes on the end of a long pole.
I think it holds about 30 cc, you fill the syringe on the end, screw it onto the arrow that has a built in air chamber then use a hand pump to charge the air chamber.
When everything works right, on contact with the animal as the needle penetrates the hide it pushes back a release arm and the air charge moves the plunger forward to inject the medicine.
When it reaches the end of its travel it pushes the release arm forward and the arrow/syringe drops to the ground.
Often I would just walk up to a cow out on pasture and poke it by hand.
Our cows were quiet enough that it worked fine the first time you treated them.
If you had to treat the same cow a second time you needed to use the crossbow as by then they learned what that orange poky thing in your hand was and would try to avoid you.
Way more convenient than trying to bring them all back a mile or two to the handling facilities to treat one or two.
Probably only used it a couple of dozen times in the 15 years I have had it but it definitely was money well spent.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
