I try (if at all possible), to avoid replacement ends. Developing bad connection at the post, is bad enough, without adding more misery and headache to the cable.
My experience with add on ends. Sooner, or later you'll run into a bad connection problem. Caused by corrosion, or whatever. Not all that big of a deal, if it happens right outside your shop at home, where you got all your parts and tools to fix it. Unfortunately, that doesn't seem to ever be where it happens out. It's always at the fuel pumps at a (self service) gas station. Or in the parking lot after church. It never fails, it always happens in places like that.
Another beef I got with replacement ends, everytime you put one on, it basically requires you to clip the old end off. If nothing else, clip some of the cable off to get back to some fresh cable to apply the new end to. We all know that, original cables are none to extra long. So then you are fighting the whole cable being barely long enough to get on the battery post thing when done.
I just avoid replacement ends if I can. About the only time I consider them, is if it is going to be a heck of a lot of grief to replace the whole cable.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Repairing A Massey Harris 22 - by John Reeves. I have just given this old girl (boy?) a replacement RH rear axle. I was lucky enough to find an axle in good shape at a reasonable price - also a replacement for the right rear brake assembly which was
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
