Hello JaJa welcome to YT! We had a 1070 on the farm as I was growing up in the 70s and 80s in fact my uncle still has it. So memory may be a little fuzzy. My question is to drain the fuel did you do that by unhooking the fuel line that feeds the engine fuel or is there a plug in the tank. What I am trying to establish by this question is if there is something in the tank floating around that might block the fuel fitting were it goes out of the tank, this is many times a piece of plant stem or bug etc. If you drained it by disconnecting the fuel line and it did not stop running out it is probably not you issue. There is the fact that while you are draining the tank, the tractor is still and not sloshing the fuel around in the tank. Probably still worth looking down in the cap with a good flashlight. I also realize you will not be able to see as much doing this as I am used to when doing this on an old Farmall. The clicking you hear is likely the check valves in the primer that allow the plunger of the primer to pump the fuel. Just FYI there is also a J. I. Case specific forum on this site. To get to it depending what ..View.. you are in you use the ..Jump to.. or ..Hop to.. drop down box seen below when viewing your post you can navigate to those topic sections. If you do not get many other replies here after a day or so you can try posting this over there.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I�m handing him tools and he says, "give me that..." and I�ve already got it in his hand or "hand me that....."and I�ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
