Posted by used red MN on May 05, 2022 at 15:59:18 from (172.58.86.167):
In Reply to: starter brushes posted by pinball on May 05, 2022 at 13:10:55:
Been a while since I worked on one with the band and windows in the case. I think you can go about it the same way as the later models the case has no band and the back bearing plate is a heavier stamped flat plate that only holds the bushing but does not support the brushes as the one you have does. Place the assembled nose with drive and armature in a vise so the commutator end is up. Slide the case down on it. Now place the end cap with the brushes on top of it aligned to the wires properly. Now spread the brushes out one at a time to get them to go over the commutator. A couple brushes may need install once the end cap is placed on top due to them connecting to the field leads. One of SVCummins girl friends will show you how to do it near the end of the linked video. Also the method rustred and Leroy are describing is for Ford and some Chrysler style starters that have coiled up flat springs and the the brushes slide in a rectangular receptacle.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
