Posted by old on March 24, 2022 at 19:26:54 from (67.142.112.130):
In Reply to: Reusing head gasket posted by 37 chief on March 24, 2022 at 16:14:22:
Back around 1977 my dad had a Gravely brush hog walk behind machine. It has a single cylinder engine. I was home on leave from the Navy and the neighbor had borrowed it. They could not get it to run. I looked at it and one of the valve had stuck open again. Ha that problem a number of times. I pulled the head off and freed up the valve. I then started to put the head back on using the used head gasket. There where a couple of high school kid watching me and they said you can't do that the head gasket will never seal. They where in the high school shop class. I told them watch and learn. At the time I was maybe 19 or 20. It by the way worked just fine
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
