Posted by Steve@Advance on March 22, 2022 at 15:33:14 from (24.182.105.214):
In Reply to: Won't turn very short? posted by Tractorcedric on March 22, 2022 at 13:38:18:
First thing I would check is that the steering will turn all the way to the end of the steering gear travel, both ways, before the tie rod length stops it. Might be easier to take the tie rods off the pitman arm first.
Then count the turns from lock to lock. The arm should be the same distance from the side of the opening on both sides. Then go back 1/2 the turns and see if the pitman arm is pointing straight ahead, equal distance from each side of the opening. That will tell if the gear is operating and assembled as it should be.
With the gear still straight ahead, set the toe in, keeping the wheels equally straight as you make adjustments.
One more thing to check, before setting the toe in, that the arms are tight to the spindle shafts. Any slack at all will loose turning radius and change the toe in.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
