Posted by RobT05 on February 23, 2022 at 00:08:11 from (184.53.32.84):
Hello,
I am having an issue with a Case 1740 Uniloader with the D188 diesel engine in it. It has a key, but is push button start. When I try to start the engine it will crank as though it wants to start, but will not fire up, and when I let off of the push button the engine quits cranking but the starter continues to make noise and eventually smokes like it is still spinning and burning itself up.
I recently had the starter rebuilt as I allowed a friend of mine to borrow the machine, and he claimed he somehow was able to start the machine by just turning the key. Had to replace a fuse by the instrument panel as well. Recently replaced the water pump and did a fuel filter replacement as well. The machine fired right up after the filter replacement. I worked it for a half a day and it was smoking while under load, and as I drove up hill it was losing power to the point it would just stop dead in its tracks going uphill.
Any suggestions or advice as to what may cause the starting issue? Any suggestions or ideas why it is losing power? If I can get it started would like to trade it off or sale it as it is actually not big enough for what I had bought it for. And it frequently does not perform well in the mud here in Western Pennsylvania.Thanks for any help!
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Revival of a John Deere Combine - by The Red, John Fritz. For several years I had been driving by a farm house on the west side of Indianapolis that had a John Deere combine parked in high weeds in a lot behind the house. The gentleman no longer farmed because the entire area was developed with housing and light industry. I had stopped several times and knocked on the door but no one would answer. My curiosity was up and I wanted to contact the owner. I wanted to see what he planned to do with the combine.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
