Posted by Hobo,NC on February 16, 2022 at 17:41:06 from (75.137.54.152):
For those that think shops are over priced I will challenge ya to try some of the dog work we do sometime. Exhaust leak around manifold somewhere you can not see it, its covered up by more heat shields than the law allows. 2013 equinox 2.4 AWD with the old fashion A.I.R. emissions. Book time 5.9hr to R&R the manifold. To make matters worst it has codes for the A.I.R. system the pump has been replaced. The system is stopped up on the back of the head. No access from the bottom are sides you work from the top in the blind you use a mirror... Most all the bolts are hidden from eye site : ( This job draws blood my right arm looks like its been in a cat fight.
This is just emissions the manifold it down there somewhere.
The ones without A.I.R. are not as bad to do.
2015 f150 5.0 visiting from Missouri with a coolant leak a water pump has just been put on someone told him the freeze plugs were leaking. Its leaking from the water pump its a aftermarket it did not fit in the hole I had to pry it out. It got a OEM Ford pump it slid right in the hole.
Both these jobs stress you back and legs its not all pic'N and a grinning. My guess on the F150 as it looks to be poorly maintained low bidder got the contract.
This post was edited by Hobo,NC on 02/16/2022 at 05:44 pm.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
