Posted by dhermesc on February 01, 2022 at 13:04:36 from (12.206.162.122):
In Reply to: Hard Labor On The Farm posted by aFORDable on February 01, 2022 at 12:35:34:
Two terrible dirty jobs I remember.
Scooping milo out of the 3000 bushel grain bins - sometimes by the semi loads - usually by 125 bushel load for grinding feed for cattle and hogs. There would be so much dust in the air you couldn't see across the bin - and you spent the rest of the day coughing and sneezing the dirt up. By the time it was gone it was time to get back into bin and do it again.
The second was cleaning out our farrowing house. The gutters would fill up and you scooped them to the pit then dipped the pit out with 5 gallon buckets into the manure spreader with the endgate. You were hunched over to go under the farrowing pens, putting your face right down in the **** while pushing it with a shovel.
I'd rather throw small square haybales for days on end than those two jobs.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Buying your first tractor: The People You Buy From - by Chris Pratt. If you are a first-time buyer, chances are that you are likely to take the word of the seller on things. This is where the problems start... You have reviewed your implement needs and determined the size of machine that will fit the bill and even made a list of the most desirable models. You checked on the availability of a 3-point hitch for the machines on the list and advertised in your local classified paper with so
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
