Posted by gmccool on January 27, 2022 at 06:04:00 from (174.246.195.122):
I have a shingle mill that I use at our local farm show and demonstrate cutting wooden shingles and then pass them out as souvenirs. It has a 6 flat belt pulley and I lost the use of the 6 belt that I was using to power it. I have a chance to buy a new never used 8 belt. But the mill has a guide on one side of the pulley so the belt can't run off on one side. ( It has to be there and can't be moved because of grease lines going to different fittings Ect.) My question is can I use a 8 belt on a 6 pulley or will it try to center itself or start walking and rub on the guide or try to run itself off. I know a belt always walks to the high side of a pulley and because my 6 pulley is crowned in the middle will this work or not. If not I'll keep looking for a good 6 belt. Thanks Gerald
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Good As New - by Bill Goodwin. In the summer of 1995, my father, Russ Goodwin, and I acquired the 1945 Farmall B that my grandfather used as an overseer on a farm in Waynesboro, Georgia. After my grandfather�s death in 1955, J.P. Rollins, son of the landowner, used the tractor. In the winter 1985, while in his possession the engine block cracked and was unrepairable. He had told my father
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
