Posted by fixerupper on January 15, 2022 at 14:13:09 from (100.42.82.64):
In Reply to: Dozer Lowboy posted by redforlife on January 15, 2022 at 09:31:28:
Last night I was watching a You Tube vid showing a guy in Vietnam loading a mini-hoe onto a beat up single axle dual wheel bumper hitch trailer being pulled by a small single axle dual wheel truck. He flopped the ramps down and when he backed the hoe on the trailer the back wheels of the truck came up off the ground and the trailer tipped back to where the ramps aligned just perfect with the trailer deck. After he had backed on most of the way the truck slowly came back down. When the hoe was clear to the front of the trailer it still looked tongue light. He did not chain the hoe but he didn't go fast when he took off. The guy with the camera followed him a half mile or so down the narrow streets To where the hoe was unloaded with the truck leaving the ground again. The hoe operator had the bucket on the ground while he loaded and unloaded so the truck and trailer wouldn't scoot away from under him. I could tell this wasn't his first rodeo.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
